Support

Product Help Centre

Set-up guides, care tips and how-to videos for your Crashpad gear.

SwagsSet-up, care & pole tips
Sleep SystemSet-ups, zipping & packing
StretcherQuick set-up guide
Wheel bagsFitting & buying guide
WalkthroughsProduct video tours

Swags

How to set up your swag

Watch the video or follow the steps below and you'll have your swag up in no time.

Tip: the base is fully waterproof, but a Crashmat underneath adds an extra layer of protection.

Shop Crashmats

Step by step

Roll it out
Take your swag out of its carry bag and place it on flat ground, clear of debris and sharp objects.
Unclip and unpack the poles
Unclip the webbing straps, roll the swag out flat and take the poles out of the black PVC pole bag.
Fit the curved end poles
For each end pole: extend the folded pole, fit both ends onto the corner rod pins, then clip on the bow clips, starting with the top two and working down each side.
Add the centre pole
Extend the centre pole and clip each end onto the middle of a curved pole. Your swag is now standing. Peg out the awning at each end.
Peg down and open up
Depending on the weather, peg the swag down using the corner peg loops, then open the doors and end ventilation windows.

Swags

Hot tips & tricks

Swag hacks: helpful hints to up your swag game

To keep your swag poles going strong, avoid these:

Over-bending the poles during set-up or pack-up. It stresses the pole sleeves and can lead to breakages.
Using the poles as a leaning post or to help pull your boots off. The car bonnet is much better for that.
Falling on it after a big session around the campfire. Aim for the ground next to the swag. Your swag will thank you in the morning.

Pole tip: always fit both ends of a curved pole into the corner pins before clipping on any bow clips. Clipping on with only one end in puts too much tension on the pole and can break it.

Mattress tip: give a new mattress at least 24 hours out of its packaging to air and return to its full size.

Looking after your swag

Pre-conditioning

Set your swag up, remove the mattress and thoroughly soak the outside canvas with water. The thread and canvas swell and take up any potential leaks in the stitching. Let it dry fully, especially the seams, as the drying is what seals them. Do this twice.

Cleaning

Use cold water and a soft brush or sponge on the canvas and PVC base, and clean the zips regularly with a soft brush and a damp cloth.

Never use soap, detergent, insect or pesticide sprays, petrol, oils, solvents or incompatible water repellents. They damage the materials and void your warranty.

Drying & storage

Make sure your swag is completely dry before storing it to stop mildew. Store it off the floor in a dry place, out of direct sunlight. Packed up wet? Set it up again as soon as you get to camp or home and let it dry out fully.

Choosing your spot

Pick clear, flat ground away from overhanging branches, open flames, creek beds and spots where water pools. Never use combustion cooking or lighting appliances inside your swag. Open the end windows for airflow to cut down condensation.

Sleep System